Home Categories Send inquiry

News

10KV Cable Branch Box Product Introduction

The product introduction of 10KV cable branch box is as follows: The 10KV cable distribution box adopts a high-performance SF6 load switch with SF6 insulating gas inside and a touchable shielded silicone rubber cable joint. It has a strong active load and no-load current breaking capacity, and ca... Read More

10~35KV Medium Voltage Cable Connector Introduction

Cable Branch Box The main parameters This device is widely used in 10/35kV power cable systems. It is widely used in power systems due to its fully sealed, fully insulated, maintenance-free, corrosion-resistant, compact structure, easy installation, safe and reliable, and high electrical paramet... Read More

What is sensor?

A sensor is a detection device that can feel the information being measured, and can transform the sensed information into electrical signals or other required forms of information output according to a certain rule, so as to satisfy the transmission, processing, storage, and display of informati... Read More

What is Insulator？

Insulator is a special insulation control device which can play an important role in overhead transmission lines. In the early years, insulators were mostly used for telegraph poles, and later they gradually developed into the high-voltage wire connecting tower with a lot of disk-shaped insulator... Read More

Installation points of power cable joints

Cable terminal heads and intermediate joints are important components in power transmission and transformation cable lines. Their function is to disperse the electric field at the cut-off part of the outer shield of the cable terminal head, protect the cable from breakdown, and have internal and ... Read More

The role of each component of the cable connector

The cable plug head mainly includes three parts: branch gloves, semi-conductive tube (stress tube), and insulating sleeve; the elbow joints seen in switch stations and box transformers are actually equivalent to insulating sleeves. Of course, equipment manufacturers will Equipped with a semi-cond... Read More

How to deal with the heating of the high-voltage cable branch box

When the high-voltage cable branch box heats up, it is controlled according to certain methods and methods to ensure that it will not be affected to a certain extent in the actual treatment, and affect the operation and value in actual use; first, perform temperature monitoring, according to the ... Read More

Knowledge of Deadbreak Tee Connector

What is the difference between the front connector and the rear connector of the Deadbreak connector! Generally speaking, under normal circumstances, a set of front connector are needed to enter a three-core high-voltage cable in a ring main unit. If it is connected through a wall bushing,after i... Read More

Shielded T Rear Surge Arrester

The function of the surge arrester is to protect various electrical equipment in the power system from damage caused by lightning overvoltage, operating overvoltage, and power frequency transient overvoltage. The main types of lightning arresters are protective gaps, valve arresters and zinc oxid... Read More

Deadbreak cable connectors

There are many forms of cable connectors, and different forms have their own characteristics. Among them, the Deadbreak cable connectors are fully insulated and fully sealed terminal cable heads that can be touched with electricity; they are widely used in outdoor distribution transformers, box t... Read More

Cable branch box installation knowledge

The cable branch box must meet the requirements of convenient installation, and the incoming and outgoing wires must be flexible enough to facilitate installation; in general, the cable branch box should have 6 to 8 branch inlets and outlets, so that it can be used. Meet the circuit transmission ... Read More

Detailed Overview of Cable Fault Indicators

What is a cable fault indicator? Fault indicator is a kind of electromagnetic induction equipment that can reflect that there is a short circuit current through the fault sign (red card). Install the fault indicator along the distribution line. Once the line fails and the short-circuit current fl... Read More
<< < Previous 6789101112 Next > >> Page 9 / 15